This is a steering linkage set for the Axial SCX24. The linkage set will eliminate most of the play found in the stock linkage. It is a direct replacement for the factory parts with no modifications needed. Included are (2) complete sets of linkages. Share with a friend or have a spare set. Pay attention to the correct orientation of the upper link. The angled end attaches to the servo horn.

**IMPORTANT** You should use either a 1.1mm or a #57 (.043") drill bit to clean out the screw hole for the ball end. There is always a small amount of unsintered powder left in deep holes despite the cleaning process.

Product link: https://www.shapeways.com/product/PP...onId=108773656











Here is a short video comparing it to stock and demonstrating it in action.




Thanks for looking! Please post any questions below.