sbg  

RPP Associated
Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16

Thread: Another Rendering Grabbed Me!!! Winnebago Time!!!

  1. #11
    Join Date
    May 2017
    Posts
    51

    Default

    Subscribed! :)

  2. #12
    Join Date
    Aug 2014
    Posts
    486

    Default

    Epic stuff

  3. #13
    Join Date
    Dec 2014
    Location
    In The Shop!
    Posts
    1,802

    Default

    Thanks Guys! So I have tackled a few of the features that I knew would be a bit challenging.
    1st - the roll back deck. I picked up an actuator with a 4" stroke and is 12vdc. After some trial and error I got the deck to actuate as envisioned, rolls back, tilts and unloads the "Bug". Now if I could figure out how to upload videos I'd be all set!
    2nd - The raise lower system using 2 servos rear and so far just one in front. The cantilever idea does work, I had my doubts until I installed the servos.IMG_2022.jpgIMG_2045.jpgIMG_2020.jpgIMG_2007.jpgIMG_2033.jpgIMG_2035.jpgIMG_2043.jpg
    https://www.youtube.com/watch?v=fIseq0x34dw

  4. #14
    Join Date
    Mar 2018
    Posts
    951

    Default

    nice and genius

  5. #15
    Join Date
    Dec 2017
    Posts
    117

    Default

    Very cool Winnebago

  6. #16
    Join Date
    Dec 2014
    Location
    In The Shop!
    Posts
    1,802

    Default

    Thanks Guys!!

    Adding all the trim. Using the rendering as a guide. So far have used between #evergreen and #plastruct roughly 25' give or take of various sizes and shapes of styrene strips, L and tube. Getting close to resembling the rendering, "Bug" will be parked further up the deck to match, wish there were more renderings to go by. #teamknkhardware #nankinhobby #exclusivercIMG_2319.jpgIMG_2298.jpgIMG_2316.jpgIMG_2309.jpgIMG_2305.jpg

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •