PDA

View Full Version : NCYota Double Shear Knuckles and Lockouts for Ascender, NCYota and TM8/TMX



new2rocks
02-10-2018, 03:55 PM
BowHouse RC is excited to announce the NCYota Double Shear Knuckles and Lockouts. These are a direct fit for the Vaterra Ascender, BowHouse RC NCYota, and GCM Racing TM8/TMX axles. They are available as knuckles only or as a knuckle/lockout combo.

19957

19958

Features:

Double-shear knuckle design for extra strength, durability and steering response
Mechanical stop on knuckles to help protect against over-steering
Improved geometry vs. stock Ascender knuckles to reduce stress on CVDs
Improved wheel/tire clearance compared to stock Ascender knuckles
Lockouts feature integrated brake dust shield
Available with knuckles only or knuckle/lockout combo
Bolt-on solution uses stock hardware with no modifications required


The double-shear knuckles correct the gap between the bottom of the stock knuckles and the c-hubs. Here is a close-up of the stock knuckle:
19948

When under load, this can create upward pressure on the CVDs and increase stress/wear of the CVDs. Our knuckles eliminate that gap:
19949

Here are some more pictures installed:
19953

19952

19954

19955

19956

These are available for purchase through our website (http://www.bowhouserc.com), on our Shapeways store (https://www.shapeways.com/shops/bowhouse-rc) and at RPP Hobby (http://www.rpphobby.com).

Thanks for looking!