sbg  

RPP VS4 2018
Results 1 to 2 of 2

Thread: Hairba11s Datsun

  1. #1
    Join Date
    Jun 2017
    Posts
    130

    Default Hairba11s Datsun

    My original Datsun build was a cc01 chassis with leaf springs in the rear and an exo cage with a big bear body.

    Here goes round two.


    I hacked the back of the chassis off and added frame rails from 1/2x1/8 steel


    Then I made the kick up in the rear for the axle.


    A 3D printed Datsun cab fits nicely.


    A honcho bed finishes it nicerly.


    I made a floor pan from 22ga galvanized.


    It holds up the back of the cab and reinforces the rockers


    I hacked of more of what was left of the front end


    And made a simple skid plate


    Approach angle should be pretty good even with the IFS tombstone


    Then I attached the trayback to the back wall of the cab.







    I did math based on widths, and at 8.75 the blazer is about 9.4:1 so I printed the Datsun at 7.2 wide so it looks right. Putting them side by side the lifted Datsun is almost the same height as the stock blazer. Feels about right to me.



    Sent from my iPhone using Tapatalk

  2. #2
    Join Date
    Aug 2014
    Location
    Smithfield, RI USA
    Posts
    1,594

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •